Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO CLEAN
Tips
Cleaning the particle sensor(clean every 2 months)
1. Open the particle sensor cover.
Wet a cotton ball with a small amount
of water and wipe the lenses (2),
dust inlet, and vent, then wipe again
with a dry cotton ball to remove moisture.
* If cleaning is not done regularly, the
particle sensor may not work as well.
* The cleaning cycle differs depending on the purifier's surroundings. Clean more often
in dusty environments.
2. Clean the dust intake and vent with a soft brush or vacuum cleaner.
* Take care that dust does not fall inside the purifier while cleaning.
Cleaning the air intake and outlet (clean every 2 months)
Clean the air intake and outlet with a soft brush.
* Take care that dust does not fall inside the purifier while cleaning.
Cleaning the front cover
Remove the front cover from the purifier and then wipe away dust stuck
to the surface with a soft, dry cloth or soft brush.
* If there is severe contamination, use a damp cloth
(do not use abrasives).
Cleaning the purifier itself (clean every 2-4 weeks)
Wipe with a soft, dry cloth.
* If there is severe contamination, use a damp cloth
(do not use abrasives).
17
- Always unplug the power before cleaning.
- Do not use detergents containing organic solvents
(solvents, thinners, etc.), bleach, chlorine, or abrasives to clean.
- Do not immerse the purifier in water or sprinkle water on it.
Dust outlet
Dust inlet
Vent
air intake
Publicidad
