Worx WG743E Serie Manual Original página 15

3. Set mower at highest cutting height when
mowing in rough ground or in tall weeds.
Removing too much grass at one time can
cause circuit breaker to trip, which stops
mower.
4. If a grass bag is used during the fast growing
season, the grass may tend to clog up at the
discharge opening. Release bail handle to
turn mower "OFF" and remove the safety key.
Remove the grass bag and shake the grass
down to the back end of the bag. Also clean
out any grass or debris which may be packed
around the discharge opening. Replace the
grass collection bag.
5. If mower should start to vibrate abnormally,
release bail handle to turn mower "OFF" and
remove safety key. Check immediately for
cause. Vibration is a warning of trouble. Do not
operate mower until a service check has been
made.
6. ALWAYS RELEASE BAIL HANDLE TO TURN
MOWER "OFF" AND REMOVE SAFETY KEY
WHEN LEAVING IT UNATTENDED EVEN FOR A
SHORT PERIOD OF TIME.
CUTTING AREA
The cutting area can be affected by several factors,
such as cutting height, lawn humidity, grass length
and density. Besides, starting and stopping the
mower too many times during operation will reduce
the cutting area.
The below table provides the potential cutting areas
based on specific cutting conditions.
Cutting Height
Cutting off 8cm to 6cm
* Used with two fully charged battery packs.
TIPS:
1) It is recommended to mow your lawn more
frequently, walk at normal pace, and not
to start/stop the mower too often during
operation. Please always use the same two
batteries and charge the two batteries at same
time.
2) For best performance, please ensure use a fully
charged battery pack and always cut off 1/3 or
less of the grass height.
3) Walk slowly when cutting long grass, so as
to have more effective cutting and properly
Cordless Lawn mower
Recommend lot
size (maximum)
With 2*20V / 4.0Ah
batteries
up to 500m *
2
discharge the clippings.
4) Avoid cutting wet grass, otherwise it will stick
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new
or thick grass and it will extend the battery
duration.
MAINTENANCE
WARNING: Stop the mower and remove the
safety key before removing the grass bag.
NOTE: To ensure long and reliable service,
perform the following maintenance procedures
regularly. Check for obvious defects such as a
loose, dislodged or a damaged blade, loose fittings,
and worn or damaged components. Check that
the covers and guards are all undamaged and
are correctly attached to mower. Carry out any
necessary maintenance or repairs before operating
mower. If the mower should happen to fail despite
regular maintenance, please call our customer
helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS REMOVED.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade,
removing equal amounts of material from both
ends.
NOTE:
1. Be sure the mower is turned off and remove the
key.
2. Place the mower in stand up storage mode.
TO SHARPEN BLADE IN A VISE (SEE Fig.L1)
1. Be sure the bail handle is released, the blade
has stopped and the safety key removed before
removing the blade.
2. Remove blade from mower. See instructions for
removing and attaching blade.
3. Secure blade L1-1 in a vise L1-2.
4. Wear safety glasses and be careful not to cut
yourself.
15
EN