Descargar Imprimir esta página

Qilive Q.6343 Manual De Instrucciones página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
can be detached from the main filter by gently squeezing the tabs at the top and
EN
pulling it away.
3.
Larger food remnants can be cleaned by rinsing the filter under running water. For
a more thorough clean, use a soft cleaning brush.
4.
Reassemble the filters in the reverse order of the disassembly, replace the filter
insert, and rotate clockwise to the close arrow.
WARNING
Do not over tighten the filters. Put the filters back in sequence securely, otherwise
coarse debris could get into the system and cause a blockage.
Never use the dishwasher without filters in place. Returning the filter to the
incorrect position can reduce the performance level of the appliance and damage
dishes and utensils.
Spray arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
1
1.
To remove the upper spray arm, hold the nut in the center still and rotate the spray
arm counter-clockwise to remove it.
2.
To remove the lower spray arm, pull out the spray arm upwards.
3.
Wash the arms in soapy and warm water and use a soft brush to clean the jets.
6.3. CARING FOR THE DISHWASHER
Frost precaution
It is necessary to take frost protection measures on the dishwasher in winter.
Every time after washing cycles, please operate as follows:
1.
Cut off the electrical power to the dishwasher at the supply source.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain the water from the inlet pipe and water valve. (Use a pan to gather the
water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the filter at the bottom of the tub and use a sponge to soak up water in
the sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the door slightly
open for a while so that moisture and odors are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove the plug from the socket.
2
14
3

Publicidad

loading