Qilive Q.6343 Manual De Instrucciones página 9

Syphon connection
The waste connection must be at a height less than 1000 mm (maximum) from the
bottom of the dishwasher.
4.4. POSITIONING THE APPLIANCE
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is
equipped with water supply and drain hoses that can be positioned either to the right or
the left sides to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned for levelling,
the height of the dishwasher may be altered via
adjustment of the screwing level of the feet.
In any case, the appliance should not be inclined
more than 2°.
4.5. Free Standing Installation
Step 1. Fitting between existing cabinets
The height of the dishwasher, 845 mm, has been
designed in order to allow the machine to be fitted
between existing cabinets of the same height in
modern fitted kitchens.
The laminated top of the machine does not
require any particular care since it is heatproof,
scratchproof and stainproof.
Step 2. Underneath existing worktop (When fitting beneath a worktop)
In most modern fitted kitchens, there is only one
single worktop under which cabinets and electrical
appliances are fitted. In this case remove the worktop
of the dishwasher by unscrewing the screws under the
rear edge of the top (a).
Attention
After removing the worktop, the screws must be
screwed again under the rear edge of the top (b).
9
EN
a
a
b
b