Publicidad
Idiomas disponibles
Idiomas disponibles
PART I: GENERIC VERSION
4. INSTALLATION INSTRUCTIONS
WARNING
Electrical Shock Hazard!
Disconnect electrical power before installing dishwasher.
Failure to do so could result in death or electrical shock.
Attention
The installation of the pipes and electrical equipment should be done by professionals.
4.1. ABOUT POWER CONNECTION
WARNING
For personal safety:
•
Do not use an extension cord or an adapter plug with this appliance.
•
Do not, under any circumstances, cut or remove the earthing connection from the
power cord.
Electrical requirements
Check the rating plate for the rated voltage. Connect the dishwasher to the appropriate
power supply. Use the required fuse 10A/13A/16A, time delay fuse or circuit breaker
recommended and provide separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power correspond to those on the rating
plate. Only insert the plug into an electrical socket which is earthed properly. If the
electrical socket to which the appliance must be connected is not appropriate for the
plug, replace the socket, rather than using adaptors or the like as they could cause
overheating and burns.
Ensure that proper earthing exists before use.
4.2. WATER SUPPLY AND DRAIN
Cold water connection
Connect the cold water supply hose to a
threaded 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is
clear. This precaution is needed to avoid
the risk of the water inlet to be blocked and
damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking and when
the air space between the supply hose itself and the outer corrugated hose is full of
water.
Ordinary supply hose
7
EN
Safety supply hose
Publicidad
