Publicidad
Idiomas disponibles
Idiomas disponibles
m IMPORTANT!
You must fully assemble the appliance before using it
for the first time!
10. Initial operation
Before start-up, place the splitter on a stable, level
and flat workbench at a height of 72 - 85 cm. Fix the
machine to the workbench with two screws (M8 x X
= thickness of the workbench). To do so, use the two
holes on the foot (16).
Make sure the machine is completely and expertly as-
sembled. Check before every use:
• the connection cables for any defective spots
(cracks, cuts etc.).
• the machine for any possible damage.
• the firm seat of all bolts.
• the hydraulic system for leakage.
• the oil level and
• the safety devices
10.1 Checking the oil level (fig. 15)
The hydraulic unit is a closed system with oil tank, oil
pump and control valve. Check the oil level regularly
before every use. Too low an oil level can damage the
oil pump. If the oil level is at the lower notch, then the
oil level is at a minimum. Should this be the case, oil
must be immediately added. The upper notch indicates
the maximum oil level. The machine must be on level
ground. Screw in the oil dipstick fully, to measure the
oil level.
10.2 Ventilation screw
Before operating your machine, the bleed screw (7)
should be loosened by some rotations until air can go
in and out of the oil tank smoothly. Failed to loosen the
bleed screw will keep the sealed air in hydraulic system
being compressed after being decompressed. Such
continuous compression/decompression will blow out
the seals of the hydraulic system and cause permanent
damage to your machine. Before moving your machine,
make sure the bleed screw is tightened to avoid oil
leaking from this point.
28 | GB
10.3 Splitting logs
Only split logs that have been sawn off straight. To do
this, proceed as follows:
1.
Place the log plain onto the work table (9).
2.
Your machine is equipped with Two-hands Con-
trol System that requires to be operated by both
hands of the user – left hand controls the control
lever (12) while right hand controls the push button
switch (6).
3.
Simultaneously push button switch (6) to start the
splitting action.
The log splitter will freeze upon absence of either hand.
Never force your machine for more than 5 seconds by
keeping pressure on it to split excessively hard wood.
After this time interval, the oil under pressure will be
overheated and the machine could be damaged. For
such extremely hard log, rotate it by 90° to see whether
it can be split in a different direction. In any case, if you
are not able to split the log, this means that its hardness
exceeds the capacity of the machine and thus should
be discarded to protect the log splitter.
10.4 Hoist limiting
It is reasonable to limit the hoist of the pressure plate
(10) for short splitting material. Thereto press the con-
trol lever (12) and the release button (6) and let the
pressure plate (10) move just in front of the splitting
material.
Release the release button now and mount the hoist
limiting ring (7a) to the housing and tighten it. After-
wards you can release the hydraulics lever.
The pressure plate will now be resting in the selected
position.
10.5 Wrongly placed log (fig. 11)
Always set logs firmly on the log retaining plates and
work table. Make sure logs will not twist, rock or slip
while being split. Do not force the blade by splitting logs
on the upper part. This will break the blade or damage
the machine.
Do not attempt to split 2 pieces of logs at the same
time. One of them may fly up and hit you.
www.scheppach.com
Publicidad
