Publicidad
Idiomas disponibles
Idiomas disponibles
support system for horizontal installation and a protective grid which prevents inhabitants of the pond from being
sucked in (please refer o section 5.6 Submersible dirty water pumps from SPIDO are suitable for stationary or
temporary installations. The pump is not suitable for use in table-top fountains, aquariums or similar ranges of use.
This product was developed for private use, i.e. not for industrial applications.
The pump is not suited to discharge saltwater, faeces, inflammable, etching, explosive or
other hazardous liquids. Please observe the max. temperature of the liquids to be
discharged stated in the technical data.
Inside the pump, lubricants are used which may contaminate the liquids being discharged in
case of any improper operation or damage of the device. The lubricants used are
biologically degradable and non-hazardous to health.
3.
Technical Data
Model
Mains voltage / frequency
Nominal performance
Protection type
Pressure port
1)
Max. flow rate (Q
)
max
Max. pressure
1)
Max. delivery height (H
)
max
Max. submersion depth
Max. size of the solids being pumped
Max. fluid temperature (T
)
max
Max. cut-in frequency in one hour
Length of connection cable
Cable type
Weight (net)
2)
Min. self-priming level (A)
2)
Min. suction level (B)
2)
Cut-in level (C)
2)
Cut-out level (D)
Dimensions (L x D x H)
1)
The values were determined with free, unreduced outlet.
2)
The values between brackets refer to the illustrations given at the end of these operating instructions.
4.
Scope of delivery
The scope of the delivery of this product includes:
One pump with connection cable, two connection ports, a double-coupling, one support system, one
protection grille (already fitted), one operating manual.
Please verify that the scope of delivery is complete. Depending on the purpose of the application, additional
accessories may be necessary (please refer to the chapters titled "Installation" and "How to order spare parts").
If possible, keep the packing until the warranty period has expired. Please dispose of the packing materials in
an environmental-friendly manner.
5.
Installation
5.1.
General installation information
During the entire process of installation, the device must not be connected to the electrical mains.
The pump and the entire connection system have to be protected from frost.
All connection lines have to be perfectly tight since leaking lines may affect the performance of the pump and
cause considerable damage. If required, please use a suitable sealant to make the installation airtight.
When tightening threaded connections, please do not apply excessive force which may cause damage.
When laying the connection pipes, you should make sure that the pump is not exposed to any form of weight,
vibration or tension. Moreover, the connection lines must not contain any kinks or an adverse slope.
GB
ECC 150
230 V ~ 50 Hz
320 Watt
IP X8
(1 ¼ ")
41.91 mm
7,500 l/h
0.6 bar
6 m
7 m
22 mm
35 °C
20, evenly distributed
10 m
H05RN-F
4.4 kg
120 mm
30 mm
330 mm
150 mm
18 x 17 x 31 cm
, male
Publicidad
