Descargar Imprimir esta página

Schumacher Electric SC-200A-CA Manual Del Usuario página 9

Cargador de batería automático
Ocultar thumbs Ver también para SC-200A-CA:

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Lay the AC/DC cables away from any fan blades, belts, pulleys and
other moving parts.
6. Connect the battery, following the precautions listed in sections 6 and 7.
7. Connect the charger to an electrical outlet.
8. When charging is complete, disconnect the charger from the AC power,
remove the clamps from the vehicle's chassis, and then remove the clamp
from the battery terminal.
CHARGING A BATTERY OUTSIDE OF THE VEHICLE
1. Place battery in a well-ventilated area.
2. Clean the battery terminals.
3. Connect the battery, following the precautions listed in sections 6 and 7.
4. Connect the charger to the electrical outlet.
5. When charging is complete, disconnect the charger from the AC power,
disconnect the negative clamp, and finally the positive clamp.
6. A marine (boat) battery must be removed and charged on shore.
USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the three (3) output cable leads to the charger.
WARNING: Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the battery
cable, quick-connect and clamps.
2. Connect the output clamps to the battery, following the precautions
listed in sections 6 and 7.
3. Connect the charger to an electrical power outlet.
RING CONNECTOR QUICK-CONNECT
1. To permanently attach to a battery, loosen and remove each nut from
the bolt at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery
terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Connect the charger to an electrical power outlet.
• 9 •

Publicidad

loading