Publicidad
Idiomas disponibles
Idiomas disponibles
DETERGENT METERING VALVE
16
OPERATING INSTRUCTIONS
7. Do not allow the machine to operate in the bypass mode (with the trigger
gun closed) for more than three minutes without triggering the gun. Failure
to follow this simple rule can cause premature failure of the pump packings.
HOT WATER OPERATION:
WARNING RISK OF BURN! THE WATER TEMPERATURE COULD
BECOME VERY HOT DURING HOT WATER OPERATION.
CAUTIOUS WHEN ADJUSTING PRESSURE OR CONTROLLING
THE TRIGGER GUN/LANCE ASSEMBLY.
1. Follow preceding steps 1-7 for "Start-up / Cold water operation".
2. Move the Burner switch to the ON position.
3. Recheck the system for fuel leaks. If a fuel leak is found, TURN MACHINE
OFF IMMEDIATELY! See "Risk of Explosion or Fire" warnings. Be sure
that all damaged parts are replaced and that all mechanical problems have
been corrected prior to operation of the unit. Contact Customer Service if
necessary.
Note: Upon initial start-up, water will begin turning hot in approximately
20 seconds and will reach maximum temperature within 2-1/2 min-
utes providing that the trigger gun remains open. The burner will not
fire when the trigger is released.
HIGH PRESSURE DETERGENT: (CLEANING WITH
DETERGENTS)
NOTE: This feature is designed for use with mild detergents only. Since
the cleaning solution travels through various parts of the pressure
washer, do not use corrosives as they will cause extensive damage
as well as pose a considerable safety hazard.
1. Refer to "Risk of Bodily Injury / Detergents". Be certain to wear protective
safety attire.
2. Prepare detergent solution according to label directions. (Never pump acids,
alkalines, abrasive fluids or solvents through the unit. Due to the unknown
and often corrosive characteristics of many detergents commonly used in
the pressure washer cleaning industry, it is recommended to use only mild
detergents with this unit.)
3. Fully immerse the strainer end of the clear vinyl detergent hose into the
detergent solution.
4. To apply solution; unlock the trigger gun and squeeze the trigger. In a few
moments a detergent/water mixture will exit the nozzle. Start spraying
the lower portion of the surface being cleaned and move up, using long
overlapping strokes. Applying from the bottom up helps avoid streaking.
Allow to soak briefly. Avoid working on hot surfaces or in direct sunlight to
minimize the chances of the detergent drying, which may result in damaging
surfaces. Be certain to apply cleaning solution to a small section at a time.
5. To rinse; lock the trigger gun in the "OFF" position. Turn the detergent
metering valve to the "OFF" position. Unlock the trigger gun and spray. It
will take about 30 seconds to purge all detergent from the line. For best
rinsing results, start at the top and work down.
6. Siphon a gallon of water through the detergent injection system after each
use. This prevents the possibility of corrosion or detergent residue causing
mechanical problems during the next use.
BE
HDC-SERIES Operator's Manual
Publicidad
