JVC JX-ED11 Manual De Instrucciones página 18

Page 7
Page 17
VCR does not function when a
JX-ED11 button is pressed
(SET indicator does not light)
VCR does not function when a
JX-ED11 button is pressed
(SET indicator blinks rapidly)
new ones.
e@ Remote signals from the JX-
ED11 do not reach your
VCR/camcorder.
e@ Remove any obstacle between
the JX-ED11 and the VCR/
camcorder.
@ Check the signal receptor of
your VCR/camcorder and
point the JX-ED11's signal
transmitter at it.
Page 11
Page 10
Page 14
Shuttle search (forward/reverse)
does not engage when the
JX-ED11 shuttle knob is turned
Recording VCR does not enter
record-pause mode when you
press EDIT STANDBY button
@ Search mode select switch is
incorrectly set.
@ Set the switch correctly in
accordance with your VCR/
camcorder.
® Set the recording VCR to the
play mode.
@ PLAY button of the recording
VCR is not pressed before
EDIT STANDBY is pressed.
® Record-pause setting mode
select switch is incorrectly set
@ Set the switch correctly
according to your VCR/
camcorder.
@ With some VCRs, transition to
pause mode takes much time
on non-recorded portions of
videotape.
e Scenes should be edited end-
to-end so that the cut-in of one
scene immediately follows the
cut-out point of the preceding
one, without non-recorded
gaps between scenes on the
editing videotape.
Recording VCR does not enter
record mode after IN button is
pressed
EDIT STANDBY, IN or OUT
buttons work incorrectly for
editing with R.A. Edit function
VCR does not function even after
remote-control signals are
memorized
(SET indicator does not blink
rapidly)
VCR does not function even
when remote-control signals
have been memorized
(SET indicator blinks rapidly)
@ Record-pause release mode
select switch is incorrectly set.
@ Set the switch correctly in
accordance with your VCR/
camcorder.
@ R.A. Edit mode is not engaged.
® Remote signals of your VCR
are not received correctly.
® Perform memorizing operation
again.
@ Memorized remote signals are
not compatible with JX-ED11.
e Use another VCR.
128