Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC OPERATION OF JX-ED11 VIDEO EDITING CONTROLLER
lal) aaleltisy
© Before starting operation, the remote control codes of the JX-ED11 should be matched with the remote control signals of your playback VCR/camcorder and recording VCR. Also, the user should initially set
up the four switches inside the battery compartment. Follow the procedures below.
Yes
Set RAE. switch
Yes
Recall the preset
Check operation for playback VCR/camcorder
=>
Set Switch @ to "1"
to ON.
remote control code.
search mode.
or "2",
Do you use a JVC
© Refer to Instructions,
Do you want to use
¢ Refer to Instructions,
2
A .
E d i
i
age 14.
camcorder or
page 9.
is ees conn
=e
VCR?
4
Check operation for recording VCR record-
aes
Set Switch © to "1"
ause mode.
or "2".
VCRicamcorder?
:
Memorise the remote
:
Set R.A.E. switch
No
control signals.
No
to OFF.
@ Refer to Instructions,
Check operation to release record-pause mode
eee
Set Switch © to "1"
© Reler to Instructions
page 8.
and enter record mode on the recording VCR.
or"2".
page 12.
or Panasonic) are also preset at the factory and can be recalled
Remote control codes of other brands of camcorder/VCR (e.g. Sony
easily. Refer to instructions, pages 9 and 19.
@ For setup in J to Ef, refer to the procedures of Instructions, page 10.
TO CHECK EDITED RESULT
® Tape After
Edited
CUT-IN/OUT EDITING OPERATION (without R.A. Edit function)
v Start point
Footage
to be
excluded
Footage to be
excluded
Original Tape
= Point @
= Between ® and
® Point
Control Buttons
© Press
© Keep pressing
© Release
@ Press(LIN_]
© Press (OUT ] @ Ata point
slightly before
the cut-in point,
release the
shuttle knob.
Search
Play
Play
au
Play
Play
Play
pause
pause
pause
aan
Operation of Playback
VCR/Camcorder
Operation of
Recording VCR
Reverse
® At the next cut-in point, press
again.
J32631-001
Publicidad
