Hitachi C 10FCD Manual De Instrucciones E Instrucciones De Seguridad página 19

(4) Setting to cut cro w n m oldings at positions w and e in Fig. 25 (see Fig. 32):
q Turn the table to the left and set the Miter A ngle as follo ws:
* For 45° type cro w n m oldings: 35.3°
* For 38° type cro w n m oldings: 31.6°
w Tilt the head to the right and set the Bevel A ngle as follo ws:
* For 45° type cro w n m oldings: 30°
* For 38° type cro w n m oldings: 33.9° ( m ark)
e Position the cro w n m olding so that the lo w er surface (A in Fig. 24) contacts the fence as in Fig.
33.
Head
Bevel A ngle
Scale
Fence
r
Table
Miter A ngle Scale
Fence
B
9. Cutting easily-deform ed m aterials, such as alu minu m sash
5 m m
Cla m p Bolt
Fig. 34
10. Ho w to use the dust bag (Standard accessory)
Blade G uard
(M etal)
Dust Bag
Right
A ngle
Fig. 35
q
Base
Fig. 30
A
Table on Base
Fig. 31
M ateri als su ch as al u m i n u m sash ca n e asil y d efo r m w h e n
tightened too m uch in a vise asse m bly. This will cause inefficient
cutting and possible overload of the m otor.
W hen cutting such m aterials, use a w ood plate to protect the
Vise
Asse m bly w orkpiece as sho w n in Fig. 34.
W hen cutting alu minu m m aterials, coat the saw blade with cutting
Wood Plate
oil (non-co m bustible) to achieve sm ooth cutting and a fine finish.
Alu minu m
Sash
Wood Plate
(1) W hen the dust bag has beco m e full of sa w dust, dust will be
blo w n out of the dust bag w hen the sa w blade rotates.
Check the dust bag periodically and e m pty it before it beco m es
full.
(2) During bevel and co m pound cutting, attach the dust bag at a
right angle to the base surface as sho w n in Fig. 35.
CAUTION:
Base Surface
Head
Bevel A ngle
Scale
e
Fence
Base
Fig. 32
Fence
A
B
Table on Base
Fig. 33
Empty the dust bag frequently to prevent the
duct and the blade guard (metal) from becoming
clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
English
w
Miter A ngle Scale
Table
19