Xylem SI Analytics AVS 370 Manual De Instrucciones página 42

42
The WinVisco 3 software expects viscosity measurement devices in the address zone 1 to 8
®
(ViscoPump, AVS 350, AVS
address 0.
The current WinVisco 4 software allows the use of addresses also in the range 2-8, if they are not
already occupied by ViscoPumps, which automatically occupy the addresses from 1 upwards
according to their number. For example, in an AVS
occupied by these devices and are no longer available for connected burettes.
Address assignment for burettes when rinsing with solvents:
3.4.2
When rinsing with solvents by means of connected burettes, one or two burettes are connected to
each measurement slot, depending on whether you are rinsing with one or two different solvents. The
following addresses have to be set for the burettes:
Address for burette
1. Measuring point
2. Measuring point
3. Measuring point
4. Measuring point
Fig. 6 Address allocations for burettes
With WinVisco 3, only the first 4 measuring points can be supported with burettes for flushing with
solvent.
®
360). Burettes are expected in the address range 9 to 15 and at
Address for burette
solvent 1
9
10
11
12
®
370 with 2 ViscoPumps, addresses 1 and 2 are
solvent 2
13
14
15
0