Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION, MECHANICAL PROCEDURE (CONT.)
Step 2: Thread inlet bung with attached suction pipe onto fuel tank 1.5 to 2.5 turns past hand tight. Use
appropriate sealant for fuel transfer.
Step 3: Place inlet of FR8 Series pump housing onto the inlet bung and tighten, 1.5 to 2.5 turns past hand tight.
Use appropriate sealant for fuel transfer.
Step 1
Inlet
Bung
Suction
Pipe
SWITCH LEVER INSTALLATION INSTRUCTIONS
The fuel transfer pump on/off switch lever will need to be
installed in the field. Please see Diagram 4 for a visual
guide on the proper installation of this lever.
ELECTRICAL WIRING INSTRUCTIONS
20 amp fuse within the circuit to prevent against electrical shorts. Voltage drop in wiring varies depending on
the distance from the battery to the pump and the gauge of the wire used. If the distance is greater than the
supplied 15' 14 AWG power cable*, refer to local, state, and national electrical codes to ensure the wire is of the
correct size for this application.
*14 AWG cable not supplied with pump only models
a Fill-Rite fuel transfer pump. This product must be properly bonded or grounded to avoid the build up of static
electricity when handling flammable products. Static discharge may ignite vapors causing serious injury or
death. To minimize static electricity build up, keep the nozzle in contact with the container being filled at all
times during the filling process. Use only static wire conductive hose when pumping flammable liquid.
wire because these thin wires could overheat and cause a fire.
Step 2
Inlet
PART NUMBER
FR8 MANUAL PICS
Bung
Suction
Pipe
Fill-Rite DC fuel pumps are designed to operate at the rated voltage on the
nameplate. The FR8 Series is rated for 12V DC. Regardless of how supply
line power is provided (i.e. via a battery or hard line), Fill-Rite requires a
Electrical wiring should ONLY be performed by a licensed electrician in
compliance with all local, state, and national electrical codes (NEC/ANSI/
NFPA 30, NFPA 30A, and NFPA 70) as appropriate for the intended use of
Do not connect the positive or negative power to the green ground/earth screw
or ground/earth wire as this could cause a fire. Do not attempt to power the
pump from vehicle wiring smaller than 16 AWG such as the cigarette lighter
Diagram 4
50 10
IN. LBS.
1/2" WRENCH
Step 3
NOTICE
AND ARE NOT TO BE COMMUNICATED, DISCLOSED, REPRODUCED OR USED EXCEPT AS
PREVIOUSLY AUTHORIZED IN WRITING BY SAID COMPANY AND MUST NOT BE SUBMITTED
OUTSIDE PARTIES FOR EXAMINATION WITHOUT THE CONSENT OF SAID COMPANY
DENOTES DIMENSION CRITICAL TO QUALITY
C
THIS DRAWING AND THE PRINCIPLES AND ELEMENTS OF DESIGN
Fill-Rite Compan
EMBODIED THEREIN ARE THE EXCLUSIVE PROPERTY OF
MUST BE RoHS COMPLIANT
Publicidad
