Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION, MECHANICAL PROCEDURE (CONT.)
Step 4: The following mechanical installation should be done after the electrical installation:
A. Insert 3/4" street elbow on the outlet of the pump housing. Use appropriate sealant for fuel transfer.
B. Nozzle boot is attached to the switch plate via 2 bolts torqued to 30 in-lbs.
Step 5: Attach manual nozzle. Optional: Security Lock (see Page 9).
Step 4A
Street Elbow
OPERATION INSTRUCTIONS
30 3
IN. LBS.
3mm ALLEN WRENCH
1. If equipped with a meter, reset to "0" (do not reset while in use as this will cause damage to the meter).
2. If equipped with a lock, remove from switch lever.
3. Remove dispensing nozzle from nozzle boot.
4. Move the switch lever to the "ON" position to
power the pump (Diagram 6).
5. Insert the dispensing nozzle into the container to be filled.
6. Operate the nozzle to dispense fluid; release nozzle when the
desired amount of fluid has been dispensed.
7. Move switch lever to the "OFF" position (Diagram 6) to turn
off the pump.
8. Remove the dispensing nozzle from the container being filled and
store in nozzle boot.
9. Re-engage lock on the switch lever.
SECURITY
Your Fill-Rite fuel transfer pump is equipped with a locking hole located in the switch lever for security. With
the pump turned off and the nozzle in the stored position, a padlock can be inserted through the switch lever
(Diagram 7). Fill-Rite recommends a commercial grade laminated steel padlock with an adjustable shackle.
In order to work properly with the FR8 series, locks must have a .25" shackle diameter and a vertical shackle
clearance between 2-2.5".
The following padlock models are
compatible with the FR8
A. Master Lock
model 140DLH
®
B. Brinks
model 171-42201 or model 171-44201
®
C. Puroma
model KP401
®
D. McMaster-Carr
®
*Disclaimer: see last page
ADDITIONAL INSTALLATION INSTRUCTIONS
For meter and accessory installation, such as hoses, nozzles, swivels, breakaways, or filters and filter heads, please
refer the comprehensive Owner's Installation and Operation Manual found online at fillrite.com.
Step 4B
Series:*
Brand model 1557A54
Nozzle Boot
30 3
IN. LBS.
3mm ALLEN WRENCH
Diagram 6
Diagram 7
Step 5
Manual
Nozzle
Padlock
Publicidad
