Publicidad
Idiomas disponibles
Idiomas disponibles
C
Useful information
Troubleshooting
IMPORTANT:
Before troubleshooting, disconnect the power supply. Only
a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
There are some sounds during normal use (compressor,
refrigerant circulation).
Problem
Appliance does not
work
Appliance freezes
or cools too much
The food is not
frozen enough.
Heavy build up of
frost on the door
seal.
Possible cause
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or
the appliance runs at SUPER
modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air tight.
20
Insert mains plug.
Check fuse replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator
to a warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (on a cool setting).
At the same time shape the
warmed door seal by hand such
that it sits correctly.
EN
Solution
Publicidad
