Linea 2000 DOMO DO7298S Manual De Instrucciones página 79

Idiomas disponibles

CHARGING/EMPTYING STATION

37. Lid

38. Dust bag

39. Dust bag handle

40. Dust bag guide plate

41. Power supply cable

42. Indicator light

43. Vacuum port

44. Charging contacts

BEFORE THE FIRST USE

Put two AAA batteries in the remote control.

Set the time (see "use/use with remote control/ Clock settings").

Place the signed brushes on the vacuum cleaner. Press on them until you hear a click. The brushes and

the applience are marked with L (left) and R (right); make sure they match.

Install the charging/emptying station:

1. Place the charging/emptying station on a flat,

hard surface; allow at least 5 cm free space

behind the station and 1 m free space on

the left and right-hand sides. In front of the

charging station, there must be a free area of 2

m. If this is not the case, the robot vacuum may

not be able to find the station for charging or

emptying.

2. Install a dust bag in the charging/emptying

station (see "Replacing the dust bag").

3. Plug the charging/emptying station into the

wall socket. Make sure the power cable is not in

front of or next to the station. The charging/emptying station indicator light will flash slowly.

Allow the robot vacuum to charge fully for 12 hours before first use. See "Charging".

CHARGING

Switch on the robot vacuum machine using the power switch on the side of the machine.

Make sure the charging/emptying station is installed correctly (see above).

Press the home button on the appliance

emptying station and start charging.

www.domo-elektro.be

or remote control

. The robot will drive to the charging/

DO7298S