Publicidad
Idiomas disponibles
Idiomas disponibles
6. Start/pause button
This button immediately starts automatic cleaning, both from sleep mode and standby mode. The
vacuum cleaner will plot its own path to vacuum the entire room, and will avoid walls, obstacles, and
stairs.
This button can also be used to pause the vacuum cleaner. If you press this button again, the appliance
will continue to complete its programme.
7. Suction level adjustment
Use this button to set the suction level. A symbol for the selected setting will be shown on the display. You
can switch between normal
The robot always starts with the same suction power that was selected before it went into standby or
sleep mode.
8. Clock settings
·
Press this button to set the clock.
·
The hours on the display will flash. Set the hours by pressing the up or down arrows.
·
Then press the right arrow to set the minutes. The minutes on the display begin to flash. Set the
minutes by pressing the up or down arrows.
·
Confirm the clock setting with the start-pause button
again.
9. Spot Cleaning
The robot vacuum performs concentrated cleaning with maximum suction power
(extra powerful). The robot will take its current position as its centre when you press
this button and then create a spiral route around this centre. After reaching a radius
of 1.5 metres, it will reduce its radius in a spiral to go back to its starting position. If
the robot encounters an obstacle during this operation, it will turn 180° and continue
its spiral route in the opposite direction.
You can set the suction power to powerful
power adjustment button.
10. Schedule setting
Use this button to programme the robot vacuum cleaner to automatically vacuum at a set time every day.
·
Press the schedule settings button.
·
Set the clock using the arrow buttons.
·
Confirm the setting with the start-pause button
again.
·
Choose the preferred suction power.
·
The display will show the icon
·
The robot will now start vacuuming the room every day at the set time.
·
To cancel this setting, press and hold the schedule settings button for 3 seconds until the icon
disappears from the display.
PLEASE NOTE:
·
When adjusting settings with the remote control, you must aim it at the machine.
·
Do not use the remote control near the charging/emptying station as it may interfere with the signal
and affect its operation.
www.domo-elektro.be
and powerful
suction.
or normal for this spot cleaning by pressing the suction
at all times, so that you know this setting is in place.
or by pressing the clock setting button
or by pressing the schedule setting button
83
DO7298S
Publicidad
