Linea 2000 DOMO DO7298S Manual De Instrucciones página 92

Idiomas disponibles

red light, flashing slowly: the dust bag is full or the suction line is blocked. Check the pipe or replace

the dust bag.

red light, flashing quickly: the dust bag is incorrectly installed or not installed. Install the dust bag

correctly into the charging/emptying station.

Replacing the dust bag

When the dust bag is full, the indicator light on the charging/emptying station will turn red. Replacing the

dust bag:

1. Open the lid of the charging/emptying station.

2. Pull the handle of the dust bag so it slides upwards. This closes the dust bag.

3. Carefully pull the dust bag out of the slots using the handle.

4. Discard the full dust bag and install a new, empty dust bag in the charging/emptying station.

Installing the dust bag

1. Unfold the new dust bag.

2. Slide the dust bag guide plate into the slots provided for this purpose.

3. Push the dust bag handle down.

4. Close the lid of the charging/emptying station.

STORAGE

If you do not plan to use the appliance for a long period of time:

remove the batteries from the remote control;

fully charge the robot's battery, then set the power switch to the "off" position and store the appliance

in a dry place.

If the appliance has not been used for 3 months or more, charge the battery for 12 hours before using.

PROBLEM AND SOLUTION

The robot vacuum is not charging.

The robot vacuum has got itself stuck.

DO7298S

PROBLEM

SOLUTION

Make sure there is contact between the

charging station and the main housing. Wipe

the contacts clean with a soft cloth.

Ensure that the on/off switch on the side of

the appliance is on at all times, otherwise the

appliance will not be able to charge.

Make sure the plug of the charging/emptying

station is plugged in; otherwise, the robot

vacuum will not charge.

Move the robot vacuum so it is no longer

stuck.

Make sure there are no loose wires or other

loose objects on the floor that the robot

vacuum could get stuck on.