Linea 2000 DOMO DO7298S Manual De Instrucciones página 80

· During charging, the indicator light of the control button
the robot vacuum is fully charged, the light will be lit constantly.
PLEASE NOTE:
· Allow the robot vacuum to charge fully for 12 hours before first use.
· When the battery is low or when the robot has completed its programme, the appliance will
automatically return to the charging/emptying station for charging. If no charging/emptying station is
installed, the robot vacuum will go into standby mode.
· Ensure the on/off switch on the side of the appliance is on at all times; otherwise, the appliance will not
be able to charge.
· Make sure the charging/emptying station is always plugged in; otherwise, the robot vacuum will not
be able to find the charging/emptying station.
· You can also choose to charge the appliance earlier by pressing the home button on the appliance or
the remote control.
· If the appliance battery is completely empty, you can manually place the robot in the charging/
emptying station. Make sure the castor wheel is between the two charging contacts.
· The robot vacuum can also be charged without a charging/emptying station using the adapter port
on the side next to the on/off switch. Use adapter DO7296S-A (not included – available in the DOMO
webshop) for this purpose.
AUTOMATIC EMPTYING
When the robot has finished vacuuming, it automatically returns to the charging/emptying station.
When it gets there, it will empty itself first. To do this, it will move backwards into the charging/emptying
station, which will then empty the dust reservoir using suction. This takes 10-15 seconds. The robot will
then turn 180° and move forward into the charging/emptying station to begin charging.
· The robot empties itself every time it finishes its programme. This means after cleaning an entire
space (when used without the app) or after completing a specified task (when used with the app).
· You can only adjust the emptying frequency or start emptying manually via the app.
USE
The robot vacuum maps the room using a laser beam and thus cleans the room most efficiently. In
addition, its sensors ensure it does not collide with anything. It is advisable to tidy up the room as best as
possible and remove as many obstacles as possible.
For optimal performance and the best cleaning results, it is best to follow these tips:
· Remove loose objects, obstacles and small furniture from the ground.
· Place chairs neatly around the table or raise them off the floor.
· Remove objects and cables that could cause the robot to get stuck.
· Remove objects lower than 18 mm.
· Fold the tassels on the edges of the rugs inward to prevent the robot from getting stuck.
· Roll up or remove dark-coloured, deep-pile rugs or rugs thicker than 18 mm, as this may cause
problems for the robot.
· In most cases, anti-fall sensors will prevent the robot from falling and/or making steep descents.
However, these sensors are less effective when they are dirty or when the robot is moving on carpeted,
reflective or dark-coloured floors. Therefore, it is advisable to cordon off stairs and holes, set them as a
no-go zone, or set up a virtual wall in the app.
80
DO7298S
on top of the appliance will flash. When