HomeMatic HmIP-WTH-2 Manual De Instalacion Y Uso página 29

General system information
5 General system information
This device is part of the climate con-
trol solution of Homematic IP and
works with the Homematic IP radio
protocol. All devices of the climate
control solution can be configured
comfortably and individually with a
smartphone via the Homematic IP app.
The available functions provided by the
Homematic IP system in combination
with other components are described
in the Homematic IP User Guide. All
current technical documents and up-
dates are provided at
www.homematic-ip.com.
6 Start-up
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
For more information on teaching
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
To integrate the wall thermostat into
your system and enable it to communi-
cate with other devices, you must pair
it first.
You can either pair the wall thermo-
stat directly with the Homematic IP
Floor Heating Actuator or pair it to
the Homematic IP Access Point. After
pairing, configuration has to be done
directly on the device. After pairing to
the Access Point, configuration is done
via the Homematic IP app.
6.1.1 Pairing with the Homematic IP
Floor Heating Actuator
Please make sure you maintain a
distance of at least 50 cm bet-
ween the devices.
You can cancel the pairing proce-
dure by briefly pressing the sys-
tem button (D) again. This will be
indicated by the device LED ligh-
ting up red.
If no pairing operations are carried
out, pairing mode is exited auto-
matically after 30 seconds.
If you want to pair the wall thermos-
tat with a Homematic IP Floor Heating
Actuator, the pairing mode of both
devices has to be activated first. To do
this, proceed as follows:
• Select the required channel of the
floor heating actuator and activate
the pairing mode using a long but-
ton press. The device LED starts to
flash orange. For further informati-
on, please refer to the user manual
of the floor heating actuator.
• To remove the electronic unit (B)
of the wall thermostat from the
frame, take hold of the sides of the
electronic unit and pull it out
(see figure).
• Turn over the electronic unit (B).
• Remove the insulation strip from
the battery compartment of the
wall thermostat.
• Press and hold down the system
button (D) of the wall thermostat
for at least 4 seconds to activate
the pairing mode. The device LED
flashes orange.
29