HomeMatic HmIP-WTH-2 Manual De Instalacion Y Uso página 30

Start-up
The device LED (D) lights up green to
indicate that pairing has been success-
ful.
If pairing failed, the device LED (D)
lights up red. Please try again.
6.1.2 Pairing the Homematic IP
Access Point
First set up your Homematic IP
Access Point via the Homematic IP
app to enable operation of other
Homematic IP devices within your
system. For further information,
please refer to the Access Point
operating manual.
To add your wall thermostat to the ac-
cess point, please proceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select "Add device".
• To remove the electronic unit (B)
from the frame, take hold of the
sides of the electronic unit and pull
it out.
• Turn over the electronic unit (B).
• Remove the insulation strip from
the battery compartment of the
wall thermostat.
• The pairing mode is active for 3
minutes.
You can manually start the pairing
mode for another 3 minutes by
pressing the system button (D)
briefly.
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four di-
gits of the device number (SGTIN)
in your app, or scan the QR code.
The device number can be found
on the sticker supplied or attached
to the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
lights up green. The device is now
ready for use.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• Allocate the device to a room and
give the device a name.
• The configuration is then carried
out in the Homematic IP app.
30