HomeMatic HmIP-WTH-2 Manual De Instalacion Y Uso página 32

Start-up
• Use a pen to mark the positions of
bore holes (J) (diagonally opposite)
in the mounting plate on the wall.
J I
I J
• Now drill the bore holes.
If you are working with a stone
wall, use a 5 mm drill bit for the
wall plugs supplied. If you are
working with wooden walls, you
can use a 1.5 mm drill bit to make
it easier to screw in the screws.
• Use the supplied screws and plugs
(K) to fasten the mounting plate to
the wall.
K
• Attach the clip-on frame (A) to the
mounting plate.
• Place the electronic unit (B) back
into the frame. Make sure that
"TOP" and the arrows on the back
side point upwards and that the
K
clips on the mounting plate latch
into the openings on the electronic
unit.
6.2.3 Mounting on flush-mounted
boxes
You can mount the wall thermostat
on flush-mounting/installation boxes
using the holes (I)
If the device is mounted to a
flush-mounting box, there may be
no open conductor ends.
If changes or works have to be
made on the house installation
(e.g. extension, bypass of switch-
or socket inserts) or the low-vol-
tage distribution for mounting or
installing the device, the following
safety instruction must be consi-
dered:
Please note! Only to be installed
by persons with the relevant elec-
tro-technical knowledge and
experience!*
Incorrect installation can endanger
• your own life,
• and the lives of other users of the
electrical system.
(see figure).
32