HomeMatic HmIP-WTH-2 Manual De Instalacion Y Uso página 38

Operating modes and configuration
• The next time is shown in the dis-
play. You can change this time
using the control wheel.
• Select the desired temperature for
the next period by turning the con-
trol wheel and confirm by pressing
the control wheel briefly.
• Repeat this procedure until tem-
peratures are stored for the entire
period between 0:00 and 23:59h.
7.5.4 Optimum start/stop function
To reach the desired temperature in
the room at the defined time you can
activate the optimum start/stop func-
tion.
• Select "On" for activating or "OFF"
for deactivating the function in the
menu item "OSSF" by turning the
control wheel (E) and confirm by
pressing the control wheel briefly.
7.6 Date and time
To set the date and time, please pro-
ceed as follows:
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the symbol by turning the
control wheel and confirm by pres-
sing the control wheel briefly.
• Set the year, month, day and hour
by turning the control wheel and
confirm by pressing the control
wheel briefly.
7.7 Offset temperature
As the temperature is measured on the
wall thermostat, the temperature dis-
tribution can vary throughout a room.
To adjust this, a temperature offset of
±3.5 °C can be set. If a nominal tempe-
rature of e.g. 20 °C is set but the room
presents with only 18 °C, an offset of
-2.0 °C needs to be set. An offset tem-
perature of 0.0 °C is set in the factory
settings. To adjust the offset tempera-
ture, please proceed as follows:
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the
control wheel and confirm by pres-
sing the control wheel briefly.
• Turn the control wheel until the
desired temperature appears
(±3.5 °C maximum).
• Confirm by pressing the control
wheel briefly.
7.8 Selecting the desired
temperature display
You can adjust the temperature to be
displayed. You can also define whether
the humidity value shall be displayed or
not.
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the
control wheel and confirm by pres-
sing the control wheel briefly.
• Turn the control wheel and select
- "ACT" to display the actual tem-
perature,
- "SEt" to display the setpoint tem-
perature,
- "ACtH" for alternating between
the actual temperature and hu-
midity display and confirm by
pressing the control wheel brief-
ly.
symbol by turning the
symbol by turning the
38