Breitling AEROSPACE B70 Instrucciones De Uso página 27

PREPARATION FOR USE
CONFIGURATION MODE
This mode is dedicated to the basic analog and digital
display configuration. It allows you to align the analog hands
to the digital time display (in case of a misalignment due to
a shock). It also allows you to adapt the brightness of the
digital displays as well as their lighting duration (depending
on your preferences and exterior lighting conditions).
Browse through the different functions until the upper display shows [CONFIG].
Analog hands setup
• Press A or C until the upper display shows [HANDS],
• Press B. The upper display will show [HOUR],
• Press A or C repeatedly to have the hour hand move in either direction. A longer press &
hold of A or C will have the hand travel a greater distance, up to 15min increments. Make
sure to align the hour hand with the marking at 12 o'clock.
• Press B once the hour hand is set. The upper display will show [MINUTE].
• Press A or C repeatedly to have the minute hand move in either direction. Make sure to
align the minute hand with the marking at 12 o'clock.
• Press B once the minute hand is set
CONFIG
AEROSPACE
CHRONOMETER
28
Digital display brightness setup
• Press A or C until the upper/lower display shows
A
[LIGHT] / [L X ],
• Press B. The lower display number will start to flash
[L X ].
B
• Press A to increase this number or C to decrease it.
The watch's brightness ranges 5 settings: 1 being the
lowest brightness setting and 5 being the highest.
C
• Press B to confirm setting.
Digital display lighting time setup
• Press A or C until the upper/lower display show [LIGHT] / [XX SEC],
• Press B. The lower display number will start to flash [XX SEC].
• Press A to increase this number or C to decrease it. The running time of the digital
display ranges from 3 to 20 seconds.
• Press B to confirm setting
CONFIG
AEROSPACE
CHRONOMETER
29
A
B
C