Publicidad
Idiomas disponibles
Idiomas disponibles
1. Open the shutter, gently push the steam hose until the shutter can be locked. Refer to A.
2. Please note that extension tubes can be connected to any accessories for your needs.
Please refer I to assembly.
Cleaning tiled, sealed and hardwood floors
1. Push the angled nozzle on the steam gun and than push the floor brush on the angled nozzle, turn it around 180
degrees to secure. Please refer to G & H. Fix the cleaning cloth both clamps if needed.
2. Heat and moisture can lead to damage. Please check the heat resistance and steam effect on an inconspicuous area
using a minimal volume of steam prior to use.
3. We recommend sweeping the floor or vacuum cleaning it before using the device. The floor should be cleared of
dirt and loose particles before the wet cleaning commences. Work slowly on surfaces that are heavily soiled so that the
steam has longer to take effect.
Carpet cleaning (delicate floors)
1. Push the angled nozzle on the steam gun and than push the floor brush on the angled nozzle, turn it around 180
degrees to secure. Please refer to G & H. Fix the cleaning cloth on both clamps if needed.
2. NOTE: Please test with a minimal volume of steam before using this appliance to check the
heat resistance and impact of steam on the carpet . We recommend vacuum carpet prior to use for best results.
To avoid the risk of damage due to temperature effects, do not di-rect the steam continuously onto one spot
(maximum 5 seconds).
Cleaning with big/ small triangle brush
1. Push the angled nozzle on the steam gun and than push the big triangle brush on the on the angled nozzle, turn it around
180 degrees to secure. Please refer to E & F.
2. Push the Small triangle brush onto the steam gun firmly. Please refer to E.
3. With the diamond shaped brush you can clean at smaller surfaces (ex. Wall tiles, cupboards, working surfaces,
shower cabins, window frames etc.).
4. The large triangle brush can be used with the triangle cloth to clean and sanitize upholstery and fabrics.
Steam nozzle
1. Push the high pressured steam nozzle onto the steam gun. Please refer to B. The steam nozzle is suitable for cleaning
hard to reach areas, joints, fittings, drains, sinks, WCs, blinds or any touch points.
2. To remove stains from carpets (not wool carpets) hold the nozzle low and even above the floor.
3. Never treat a stain by aiming directly from above. Suggested distance is 1/2".
Nylon & brass brushes
1. Push the high pressured steam nozzle onto the steam gun. Please refer to figure B.
2. Push the nylon or brass tipped brush into the end of the steam nozzle. Please refer to figure J.
3. Nylon brush is ideal on delicate surfaces and is used to remove caked-on dirt from surfaces.
4. The brass brush is ideal for cleaning resistant surfaces that have been encrusted by dirt or grease.
Window wiper
1. Push the window wiper onto the steam gun so that the unlocking button on the steam gun engaged. Please refer
to C.
2. Wipe the window dry from the top to the bottom. Wipe away the dirty water with a cloth.
Detail scraper
1. Push the Detail scraper onto the steam gun firmly. Please refer to D.
2. The detailed scraper is used for cleaning stubborn dirt or stains that require a scraping tool.
3. It is not suitable for cleaning sensitive surfaces.
09
Publicidad
