Publicidad
Idiomas disponibles
Idiomas disponibles
TRAILER ATTACHMENT GUIDE
Pre-installation Instructions:
1. Ensure the Wireless Camera is fully charged.
2. Confirm the Wireless Camera is paired and functional prior
to mounting to the trailer – see PAIRING THE CAMERA section.
3. Ensure the USB cover is in place. This prevents water damage
to the camera. Replace any missing screws and washers and
tighten M4 screws with the Allen wrench tool.
4. Check if your trailer has a trailer camera aftermarket pre-wire
mount. The camera bracket should fit the pre-wire mount.
The pre-wire mount is usually close to the roof of the trailer.
If there is no trailer camera pre-wire mount, find a high
location on the back of the trailer to mount the camera.
5. Locate the trailer's 12-volt supply. Consult the trailer
manufacturer if unable to locate or identify the 12-volt
supply in the trailer.
6. Check how to connect the camera to the trailer's 12-volt supply. If the trailer has
a trailer camera pre-wire mount, check if 12-volt connection is available. If there
is no trailer 12-volt connection, the camera will run on its internal batteries.
Wireless Camera System
Wireless Camera
Back View
USB port cover is in
place and secured
with two screws
Quick Start Guide
9
Publicidad
