Publicidad
Idiomas disponibles
Idiomas disponibles
TRAILER ATTACHMENT GUIDE
E. Pull tether cable through camera bracket hole to remove tether cable slack between
the camera heatsink and bracket.
F. Locate a sturdy structural element (such as a ladder,
eyebolt, d-ring bracket, etc.) near the intended
camera location that is within reach of the provided
tether length and is parallel or above the camera
mount.
G. Loop the tether cable through the structure selected
in step F.
H. Lay the tether cable through the cable clamp as shown below.
Cable Clamp
I. Place the clamp plate over the tether
followed by the provided nut. Torque
to 30 in-lb (3.4 N-m).
Wireless Camera System
Tether Cable
CAMP247
Nut
Clamp Plate
Quick Start Guide
19
Publicidad
