Descargar Imprimir esta página

DeWalt DC300 Manual De Instrucciones página 14

Sierra circular inalámbrica de 28/36 v
Ocultar thumbs Ver también para DC300:

Publicidad

Idiomas disponibles

Idiomas disponibles

protect
you under all circumstances.
Your safety depends
on following all warnings and precautions
as well as proper
operation
of the saw. Check lower guard for proper
closing
before
each use as outlined
in Additional
Safety
Rules
for Circular Saws. If the lower blade guard is missing or not
working properly,
have the saw serviced
before using. To
assure product
safety and reliability, repair, maintenance and
adjustment
should be performed
by an authorized
service
center or other qualified service organization, always using
identical replacement parts.
Blades
A WARNING: To minimize the risk of eye injury, always use eye
protection. Carbide is a hard but brittle material Foreign objects in
the workpiece such as wire or nails can cause tips to crack or break.
Only operate saw when proper saw blade guard is in place. Mount
blade securely in proper rotation before using, and always use a
clean, sharp blade.
ACAUTION:
Do not cut ferrous metals (steel), masonry, glass,
Hardiplank®
(or similar masonry-type planking), cement board or
tile with this saw.
Do not use abrasive wheels or blades. A dull blade will cause slow,
inefficient cutting, overload on the saw motor, excessive splintering,
and could increase the possibility of kickback. Please refer to the
following table to determine the correct size replacement blade for
your model saw.
Model
Diameter
Arbor
DC300
7-1/4"
5/8"
DC310
6-1/2"
5/8"
Use only DEWALT general purpose cutting, smooth wood cutting,
or non-carbide plywood/vinyl cutting blades.
If you need assistance
regarding blades, please call 1-800-4-
DEWALT (1-800-433-9258).
Cutting
Depth
Adjustment
FIG. 9
WARNING: To reduce the risk of
serious personal injury, turn tool off
and disconnect
tool from battery
pack before making any adjustments
or removing/installing
attachments
or accessories.
D
1. Hold the saw firmly and loosen
(clockwise) the depth adjustment lever (Fig. 9, D) and move
shoe to obtain the desired depth of cut.
2. Make sure the depth adjustment
lever has been retightened
(counterclockwise)
before operating saw.
For the most efficient cutting action,
FIG. 10
set the depth adjustment so that one
tooth of the blade will project below the
material to be cut. This distance is from
the tip of the tooth to the bottom of the
gullet in front of it. This keeps blade
friction at a minimum, removes sawdust
from the cut, results in cooler, faster
sawing and reduces
the chance
of
kickback. A method for checking
for
correct
cutting
depth
is shown
in
Figure 10. Lay a piece of the material
you plan to cut along the side of the blade, as shown, and observe
how much tooth projects beyond the material.
NOTE: When using carbide-tipped
blades, make an exception to
the above rule and allow only one-half of a tooth to project below
the material to be cut.
Bevel
Angle
Adjustment
(Fig.
11)
_ WARNING: To reduce the risk of serious personal
injury,
turn tool off and disconnect
tool from battery pack before
13

Publicidad

loading

Este manual también es adecuado para:

Dc310