Descargar Imprimir esta página

DeWalt DC300 Manual De Instrucciones página 3

Sierra circular inalámbrica de 28/36 v
Ocultar thumbs Ver también para DC300:

Publicidad

Idiomas disponibles

Idiomas disponibles

IF YOU HAVE ANY QUESTIONS
OR COMMENTS ABOUT THIS
OR ANY DEWALT TOOL, CALL US TOLL FREE AT: 1-800-4-
DEWALT (1-800-433-9258)
General
Safety
Rules
_
WARNING!
Read
all instructions.
Failure
to follow
all
instructions
listed below may result in electric
shock, fire
and/or
serious
injury.
The term
"power
tool" in all of the
warnings
listed below refers to your mains-operated
(corded)
power tool or battery-operated
(cordless)
power tool
SAVE
THESE
INSTRUCTIONS
1) WORK AREA SAFETY
a) Keep work area clean and well lit. Cluttered or dark areas
invite accidents.
b) Do not operate
power tools in explosive
atmospheres,
such as in the presence
of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust or
fumes.
c) Keep children
and bystanders
away while operating
a
power tool Distractions can cause you to lose control
2) ELECTRICAL SAFETY
a) Power tool plugs must
match the outlet. Never modify
the plug in any way. Do not use any adapter plugs
with
earthed (grounded)
power
tools. Unmodified
plugs and
matching outlets will reduce risk of electric shock.
b) Avoid
body contact
with earthed
or grounded
surfaces
such as pipes, radiators,
ranges and refrigerators.
There
is an increased risk of electric shock if your body is earthed or
grounded.
c) Do not expose power
tools
to rain or wet conditions.
Water entering a power tool will increase the risk of electric
shock.
d)
e)
Do not abuse the cord. Never use the cord for carrying,
pulling
or unplugging
the power
tool Keep cord away
from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock. Replace
or repair damaged cords. Make sure your extension cord is
in good condition. Use only 3-wire extension cords that have
3-prong grounding-type
plugs and 3-pole receptacles
that
accept the tool's plug.
When operating
a power tool outdoors,
use an extension
cord suitable
for outdoor
use. Use of a cord suitable for
outdoor use reduces the risk of electric shock. When using
an extension cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and
overheating.
The following table shows the correct size to
use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the gage
number, the heavier the cord.
Recommended
Minimum
Wire Size
for Extension
Cords
Total Length of Cord
25 ft.
50 ft.
75 ft.
100 ft.
125 ft.
150 ft.
175 ft.
7.6m
15.2m
22.9m
30.5m
38.1 m
45.7m
53.3m
Wire Size AWG
18
18
16
16
14
14
12
3) PERSONAL SAFETY
a) Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the influence of drugs,
alcohol
or medication.
A moment
of inattention
while
operating power tools may result in serious personal injury.
b) Use safety equipment.
Always wear eye protection.
Safety
equipment such as dust mask, non-skid safety shoes, hard

Publicidad

loading

Este manual también es adecuado para:

Dc310