Publicidad
Idiomas disponibles
Idiomas disponibles
Installation requirements
Exception 2 : For island installation, maintain 2-½" minimum from cutout to back
edge of countertop and 4" minimum from cutout to side edges of countertop.
IMPORTANT:
To eliminate the risk of burns or fire caused by reaching over heated surface
units, avoid having cabinet storage space located above the surface units. If you
have cabinet storage space over the heating elements, you can reduce the risk by
installing a range hood that projects horizontally a minimum of 5 inches beyond
the bottom of the cabinets.
Installation guide
36
(921.2 mm)
26
7
/
29
15
/
"
16
(671.7 mm)
(761.0 mm)
A: Cabinet opening 30" (76.2)
IMPORTANT: If your cabinet have height over 37", this range cannot be installed
without supporting unit like hard block.
12 English
Install_NY63T8751S_DG68-01242A-00_EN+MES+CFR.indb 12
3"
25"
24"
3"
24"
A
/
"-37"
1
4
"
16
Recommended locations for gas piping and electrical outlets
(For models NY63*875**)
17 in
(43.2 cm)
Gas Wall Area
Recommended area for
through-the-wall and through-
the-floor connection of gas
pipe stub and shut-off valve.
9 in
(22.9 cm)
2 in
(5.1 cm)
CAUTION
You must use the rear filler kit to install the range in a freestanding cutout cabinet.
For more information, see "Optional rear filler kit" as shown below.
Optional rear filler kit
WARNING
Used to fill gap between the range back and wall. Adds a filler strip to the rear
of the range. This kit can only be used when the opening in the countertop is 25"
deep.
NOTE
If the countertop depth is greater than 25", there will be a gap between the filler
kit and the back wall.
Recommended
position
12 in
(30.5 cm)
Recommended area for
120 V electrical outlet
on rear wall
2020-03-27
11:10:05
Publicidad
