Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
WARNING
If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death.
•
DO NOT store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
•
WHAT TO DO IF YOU SMELL GAS:
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch.
- DO NOT use any phone in your building.
- Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the fire department.
•
Installation and service must be performed by a qualified installer,
service agency, or the gas supplier.
Anti-tip device
WARNING
ALL RANGES CAN TIP, RESULTING IN PERSONAL INJURY.
TIPPING RANGES CAN CAUSE BURNS FROM SPILLS, PERSONAL
INJURY, AND/OR DEATH.
INSTALL AND CHECK THE ANTI-TIP BRACKET FOLLOWING THE
INSTRUCTIONS AND TEMPLATE SUPPLIED WITH THE BRACKET.
•
To prevent accidental tipping of the range, attach an approved
anti-tip device to the floor. (See Installing the Anti-Tip Device in the
Installation Instructions.) Check for proper installation by carefully
tipping the range forward. The anti-tip device should engage and
prevent the range from tipping over.
•
If the range is pulled out away from the wall for any reason, make
sure the anti-tip device is reengaged after the range has been pushed
back into place.
•
Follow the installation instructions found in the Installation Manual.
Failure to follow these instructions can result in death, serious
personal injury, and / or property damage.
•
To prevent accidental tipping of the range, DO NOT step, sit, or lean
on the door or drawer.
•
Be sure your appliance is properly installed and grounded by a
qualified technician.
2 English
Install_NY63T8751S_DG68-01242A-00_EN+MES+CFR.indb 2
Contents
Before you begin
Important safety information
Dual fuel range components
What's in the box
Installation requirements
Location requirements
To avoid breakage
Gas requirements
Special gas requirements (gas models sold in Massachusetts)
Electrical requirements
Installation instructions
Installing your dual fuel range
Step 1. Unpack the range
Step 2. Meeting electrical connection requirements
Step 3. Accessing the power cord connection
Step 4. Installing the power cord
Step 5. Installing the conduit
Step 6. Replacing the access cover
Step 7. Connect the range to gas supply
Step 8. Convert to LP gas (optional)
Step 9. Install the anti-tip device
Step 10. Plug in and place
Step 11. Level the range
Step 12. Assemble the surface burners
Step 13. Check the ignition of surface burners
Step 14. Final installation checklist
3
3
9
9
11
11
13
14
14
15
16
16
16
16
17
18
19
21
21
22
23
23
24
24
25
26
2020-03-27
11:10:00
Publicidad
