Rear - Sony VSH-1000 Instrucciones De Funcionamiento

Rear

1 DRIVE 1 A/B - DRIVE 6 A/B connectors
(miniature D-sub 50-pin, SCSI-2 standard)
Correspond to SCSI buses 1 - 6 of the VideoStore
system.
DRIVE 1 A - 6 A: Connect to SCSI DRIVE 1 - 6
connectors of the VSR-1000 Media Control Unit
via the supplied SCSI cables. Alternatively,
connect to the DRIVE 1 B - 6 B connectors of
another VSH-1000 Media Unit positioned
upstream in the daisy chain.
DRIVE 1 B - 6 B: Connect to the DRIVE 1 A - 6 A
connectors of another VSH-1000 Media Unit
positioned downstream in the daisy chain via the
supplied SCSI cables.
2 SCSI ID setting switches
Used to set the SCSI ID numbers for the hard disk
drives 1 - 6, respectively.
The SCSI ID number setting operation should be
performed by your Sony dealer.
1 DRIVE 1 A/B - DRIVE 6 A/B connectors
2 SCSI ID setting switches
3 MU STATUS IN/OUT connectors
4 UNIT NO. setting switch
3 MU STATUS IN/OUT (media unit status input/
output) connectors (D-sub 25-pin, female)
Used to form the line for transmission of media unit
status information.
STATUS IN: When making a daisy chain
connection of VSH-1000 units including this one,
connect to the MU STATUS OUT connector of
another VSH-1000 unit located downstream of
this unit via the supplied MU STATUS signal
cable.
STATUS OUT: Connect to the MU STATUS IN
connector of the VSR-1000 Media Control Unit
via the supplied MU STATUS signal cable.
Alternatively, connect to the MU STATUS IN
connector of another VSH-1000 unit located
upstream of this unit in the daisy chain.
4 UNIT NO. setting switch
Used to set the unit number allotted to this unit.
The unit number setting operation should be performed
by your Sony dealer.
5 BREAKER button
6 ⁄AC IN connector
7 y (signal ground) terminal
7