Publicidad
Idiomas disponibles
Idiomas disponibles
•
To operate the product rearward, move the operation
control fully rearward and release it.
•
To stop the movement of the product, move the
operation control in the opposite direction in small
movements until the product is stationary.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the forward and reverse control, the throttle
control and the choke control for damage.
Make sure that the forward and reverse control, the throt-
tle control and the choke control can move smoothly.
Lubricate the controls and linkages.
Examine the safety straps for damage. Replace if it is
necessary.
Examine the vibration damping units for damage.
Examine the tension of the V-belt and look for damages.
Adjust or replace the V-belt as necessary.
Examine all rubber hoses and rubber elements for dam-
age. Replace if it is necessary.
Do a check of the hydraulic oil level.
Replace the oil in the eccentric element.
Replace the hydraulic oil.
Engine maintenance, Honda
Do a check of the fuel level and the engine oil level.
Clean the cooling fins of the engine.
2425 - 001 - 12.04.2024
Maintenance
Read and understand the
•
To change direction, turn the product around by the
handle.
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Before use,
Weekly,
each 10 h
each 100 h
*
X
*
*
*
*
X
X
X
Before use,
After the
each 10 h
first 20 h
X
O
Monthly,
Yearly, each
each 250 h
500 h
X
X
X
X
X
X
X
X
Weekly,
Yearly, each
each 100 h
300 h
11
Publicidad
