Patron RP 400 Manual Del Usuario página 16

2. Tilt the product to drain the oil.
Note:
You can also use a manual oil drain pump
to drain the oil in the eccentric element.
3. Clean the surfaces around the hole for the oil drain
plug, the threads of the hole and the oil drain plug.
Use a dry cloth and, if it is necessary, an applicable
solvent.
CAUTION:
clean around and on the oil drain plug.
4. Fill the eccentric element with oil of the correct type.
Technical data on page 18 .
Refer to
5. Install the oil drain plug.
Hydraulic system
To do a check of the hydraulic hoses
• Examine the hydraulic hoses regularly. Replace
worn or damaged hydraulic hoses.
16
Do not use water to
WARNING:
The rubber in the hydraulic hoses wears with
time. Worn or damaged hydraulic hoses can
break and the hydraulic oil can cause injury.
If you cannot tell if the hydraulic hoses are
worn, always replace the hydraulic hoses.
To do a check of the hydraulic oil level
1. Remove the dipstick from the hydraulic oil tank.
2. Read the hydraulic oil level on the dipstick.
3. If the hydraulic oil level is too low, let an approved
service center examine the hydraulic system for
leaks.
To replace the hydraulic oil
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil.
Hydraulic oil is dangerous.
Risk of burn injury. The
2425 - 001 - 12.04.2024