Patron RP 400 Manual Del Usuario página 9

Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 11 .
To set the handle to operation position
WARNING:
when you change the position of the handle.
There is a risk of injury if the handle falls on
you.
1. Hold the handle.
2. Release the lock lever and lower the handle
carefully.
To start and stop the product
WARNING:
the product during the start procedure. The
hydraulic system can cause the product to
move suddenly when the engine starts.
2425 - 001 - 12.04.2024
Operation
Read and understand the
Maintenance
Hold the handle tightly
Keep your feet away from
To start the product
1. Open the fuel valve.
2. Set the throttle control to idle speed.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
4. Set the engine ON/OFF switch to ON.
9