Patron RP 400 Manual Del Usuario página 13

Engine maintenance,
Replace the fuel filter.
To clean the product
CAUTION:
product, attach a plastic bag tightly around
the fuel tank cap. This is to make sure that
water does not go into the venthole in the
fuel tank cap.
• Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION:
directly at the fuel tank cap, electrical
components or the engine.
• Remove grease and oil from the handle.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To do a check of the safety straps
1. Examine the safety straps at the front and the rear of
the product.
2. Examine the screws and nuts on the safety straps.
3. Replace damaged safety straps.
4. Replace damaged nuts and screws.
5. Tighten loose screws and nuts.
To do a check of the engine oil level
1. Remove the oil tank cap and dipstick.
2. Clean the oil from the dipstick.
3. Put the dipstick back fully into the oil tank.
4. Remove the dipstick.
2425 - 001 - 12.04.2024
Before you clean the
Do not point the water
Before use, After the
each 10 h first 20 h
5. Examine the oil level on the dipstick.
6. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 18 or the engine manual for the correct
type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Loosen the screw (A) to remove the oil drain hose
from the holder.
2. Put a container below the oil drain hose.
3. Remove the oil drain plug (B) from the end of the oil
drain hose.
4. Tilt the product and let the engine oil run out into the
container.
5. Install the oil drain plug and tighten it.
Yearly, each
Each 250 h
500 h
O
Technical data
Engine oil is very hot
A
B
13