Tectro TP 3020 Instrucciones De Uso página 65

MODE button
Selects the appropriate operating mode. Each time you press the button, a mode
is selected in a sequence that goes from COOL, FAN, DRY, HEAT (on some models),
and AUTO(on some models). The mode indicator light illuminates under the dif-
ferent mode setting.
NOTE: On above modes, the unit operates the auto fan speed automatically.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing) temperature settings in 1°C/2°F(or 1°F)
increments in a range of 17°C/62°F to 30°C/88°F (or 86°F).
NOTE: The control is capable of displaying temperature in degrees Fahrenheit
or degrees Celsius. To convert from one to the other, press and hold the Up and
Down buttons at the same time for 3 seconds.
Power button
Power switch on/off.
LED display
Shows the set temperature while on cool,heat or auto mode. While on DRY and
FAN modes, it shows the room temperature. Shows Error codes:
E0-EEPROM error.
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensor error (on some models).
E4-Display panel communication error.
EC-Refrigerant leakage detection malfunction(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain hose and drain the collected water away.
If protection repeats,call for service.
NOTE: When one of the above malfunctions occurs, turn off the unit, and check
for any obstructions. Restart the unit, if the malfunction is still present, turn off
the unit and unplug the
power cord. Contact the manufacturer or its service agents or a similar qualified
person for service.
Operation Instructions
COOL operation
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the ADJUST buttons "+" or "-" to select your desired room temperature.
The temperature can be set within a range of 17°C~30°C/62°F~88°F(or 86°F).
4
- Press the "FAN SPEED" button to choose the fanspeed.
65