Tectro TP 3020 Instrucciones De Uso página 69

- Turn off the appliance and unplug it.
- Clean the air filter according to the instructions in the previous section. Reinstall
the clean, dry filter before storing.
- Remove the batteries from the remote control.
NOTE: Be sure to store the unit in a cool, dark place. Exposure to direct sunshine
or extreme heat can shorten the lifespan of the unit.
NOTE: The cabinet and front may be dusted with an oil-free cloth or washed with
a cloth dampened in a solution of warm water and mildliquid dishwashing deter-
gent. Rinse thoroughly and wipe dry. Never use harsh cleansers, wax or polish on
the cabinet front. Be sure to wring excess water from the cloth before wiping
around the controls. Excess water in or around the controls may cause damage to
the unit.
E
TROUBLESHOOTING TIPS
Problem Possible causes
Unit does not P1 Error Code
turn on when
pressing ON/
OFF
button
In COOL mode: room temperature is
lower than the set temperature
E0 EEPROM error
Unit does not The air filter is blocked with dust
cool well or animal hair
Exhaust hose is not connected or
is blocked
The unit is low on refrigerant
Temperature setting is too high
The windows and doors in the
room are open
The room area is too large
There are heat sources inside the
room
The unit is The ground is not level
noisy and
The air filter is blocked with dust
vibrates too
or animal hair
much
The unit This sound is caused by the flow
makes a of refrigerant inside the unit
gurgling
sound
Solution
The Water Collection Tray is full. Turn
off the unit, drain the water from the
Water Collection Tray and restart the
unit.
Reset the temperature
Contact the manufacturer or its service
agents or a similar qualified person for
service.
Turn off the unit and clean the filter
according to instructions
Turn off the unit, disconnect the hose,
check for blockage and reconnect the
hose
Call a service technician to inspect the
unit and top off refrigerant
Decrease the set temperature
Make sure all windows and doors are
closed
Double-check the cooling area
Remove the heat sources if possible
Place the unit on a flat, level surface
Turn off the unit and clean the filter
according to instructions
This is normal
69