Publicidad
Idiomas disponibles
Idiomas disponibles
6.1 Treatment steps for use on smaller areas
Start the device: Long press the control button (#8). The device starts at
1.
energy level 1 automatically, and 1 energy level indicator light (#5) will turn
on.
Check that the expiry date of the gel has not passed.
Z
2.
Apply a thin layer of Silk'n Slider Gel over the treatment surface (#1).
Slider Gel (or any other water-based clear gel) facilitates smooth movement of the treatment
Z
surface over the skin and enables conductivity. To ensure safe and efficient treatment,
always start by applying Slider Gel and apply more gel if needed.
3.
Using energy level 1, place the device on the area you want to treat. Make sure that it is in
full contact with the skin. You will feel a mild sensation of warmth.
4.
Move the device in gentle massage-like motions on the area you wish to treat. Progress
slowly and carefully. Keep moving the device ensuring that the 3 electrodes stay in contact
with the skin as you treat the area.
With the device constantly in motion, treat each area for 15 minutes.
5.
6.
Increase the energy level gradually. Using the highest energy level will get the best results,
but it's important that you set the energy level that is comfortable for the area you are
treating.
34
o
You will feel the skin temperature rise as you increase the energy level. It usually takes about
Z
1-2 minutes for the device to reach the required temperature. During the treatment your
skin will get a little red. Don't worry; this is normal.
[
Stop immediately if you feel any discomfort.
7.
Experiment by moving the device slowly across the area you are treating. If the treated area
is hot and you feel uncomfortable, try moving the device a little faster.
Clean the treated area: Remove any residual gel from the skin, then rinse the skin with
8.
lukewarm water. Dry the skin with a towel, and apply a facial cream to sooth and moisturize
the skin.
- 43
o
1-2
43
o
13-14
9
2
3
1
4
EN
EN
Publicidad
