Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Blade assembly
Time Saver: Washers for blade screws can be set on each blade screw prior to
installing blades.
Located blade attachment screws and washer in one of the hardware packs.
Hold blade arm up to the blade and align holes. Insert blade attachment screws
{along with washers) with fingers first and then tighten screws securely with a
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from underside of motor. If plastic
motor locks are installed with blade arm screws, discard plastic motor locks (save
blade arm screws and lock washers to secure blade arms). Align blade arm holes
with motor screw holes and attach blade arm with lock washer and blade arm
screws. Before securing screws permanently, repeat with remaining blade arms.
Securely tighten all screws.
Note: Tighten blade arm screws twice
LED pan assembly
lamp panel
ok
lamp panel screw
Unscrew a set screw. Attach the LED pan up to the bottom of the fan by
inserting the other two set screw heads into key hole slots, rotate it to place,
then secure the previous set screw by aligning screw hole and the hole at the
bottom of the fan, tighten the rest two set screw to secure LED pan.
NOTE: While install or remove the LED pan, please keep the insulation padsintact
carefully. Turning the set screws over-tightly or fast will damage the insulation
pads.
26
Publicidad
