Blackstone 2142EU Manual Del Propietário página 9

Model: 2142eU
IGNITION INSTRUCTIONS
1. CHECK VALVES
ensure gas is off at the supply shut off valve before checking
appliance valves�
Turn all knobs to the ❶ ❶ oFF position�
STEP 01
Push in knob and release� Knob should spring back�
STEP 02
If knobs DO NOT If knobs DO NOT spring back, replace valve assembly before using appliance. spring back, replace valve assembly before using appliance.
Rotate knob to loW then turn back to oFF� Knob should
STEP 03
turn smoothly�
3. ALwAYS CHECK BURNER FLAME BEFORE USE.
light burners and rotate knobs from HIGH to loW�
STEP 01
look below the cooking surface to view burners� When knob
STEP 02
is at HIGH, flames should be larger than when knob is at loW�
HEALTHY FLAME PATTERN
❶ ❶
❷ ❷
❸ ❸
❶ ❶
Flickers of yellow color. Flickers of yellow color.
❷ ❷
Dark blue color. Dark blue color.
❸ ❸
Vibrant blue. Vibrant blue.
BLACKSTONEPRODUCTS.COM/SUPPORT SUPPORT BLACKSTONE EUROPE.COM
3. ALwAYS CHECK BURNER FLAME BEFORE USE.
YELLOw OR IRREGULAR
If there is a sudden drop or low If there is a sudden drop or low
flame issue, please reference the flame issue, please reference the
Troubleshooting chapter. Troubleshooting chapter.
USING YOUR BLACKSTONE
2. PIEZO-ELECTRIC GRIDDLE IGNITION
do NoT lean over the appliance while lighting�
❶ ❶ Push the control knob in to
start gas flowing�
1 to 3 turns 1 to 3 turns
❷ ❷ Turn the control knob
counter-clockwise to activate
the starter�
❸ ❸ Adjust the temperature to
desired level�
STEP 01
Turn gas oN by turning the gas
cylinder handwheel counter-
clockwise 1 to 3 turns�
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
If ignition does not occur in 5 seconds:
1. Turn the burner control knob OFF.
2. Wait 5 minutes.
3. Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter. If burner does not ignite, please reference the Troubleshooting chapter.
| OWNER'S MANUAL
❶ ❶
❷ ❷
❸ ❸
STEP 02
❶ ❶ Push the control knob in to
start gas flowing�
❷ ❷ Turn the control knob
counter-clockwise to activate
the starter�
❸ ❸ Adjust the temperature to
desired level�
WARNING
WARNING
09