Grohe Sensia 36507SH0 Guia De Inicio Rapido página 15

The electrical safety of the device is
only ensured when it is connected to a
properly installed earth conductor
system. This basic safety requirement
must be ensured. When in doubt,
have your electrical system checked
by a qualified electrician. The power
specifications (frequency and voltage)
shown on the nameplate of the device
must meet the specifications of the
mains cable at the installation site in
order to prevent damages to the
device.
It is recommended to power the
device from a regular wall socket
(VDE 0701), as this facilitates easy
disconnection from the power supply
in case of service work. If a wall
socket is not within reach or if a
permanent connection is planned, a
proper separation device for each
pole is required at the installation site.
A separating device within this
meaning is a wall switch where the
contact terminals are at least 3 mm
apart. This includes LS switches,
fuses and contactors (EN 60 335).
The protective zones must
be assured in bathrooms.
If a power supply
connection is made in zone 2, then
the power supply to the shower toilet
can be established by a direct
connection, using an IPX4 connector
socket as permanent connection.
Do not use after taking a bath or
shower.
Do not pour water or cleaning agents
into or onto the toilet seat or the
remote control. It could cause electric
shock or fires.
WARNING
Risk of burns, electric shock, fires and/or
personal injury:
For devices that are delivered without
a connecting power cable or when
replacing a damaged power cable, a
special connector cable must be
purchased from an authorized dealer.
The device must be disconnected
from the power supply for any and all
installation and maintenance work and
for repairs.
This also applies if you find damages
on the power supply cable or on the
product itself.
Please ensure this by:
– setting the fuses (LS switches) of
the electrical installation into the off
position or
– by completely removing the screw-in
fuses of the electrical installation or
– by completely pulling the power plug
(if any) out of the wall socket.
When doing so, do not pull on the
cord, but pull on the power plug (if
present) instead.
Check the temperature settings of the
water and the dryer air before each
use.
Set the air dryer temperature to the
lowest level if you intend to use this
feature for a prolonged period of time.
There is a risk of burns if this feature
is used for a prolonged period of time
at high temperature settings. This
applies particularly to the following
persons: children, the elderly, ill
persons, persons with sensitive skin
and thermoregulatory dysfunctions,
the inebriated and overly tired
persons.
Do not use outdoors, including areas
with large vibrations, and do not
operate in a space where aerosol
spray is used or concentrated oxygen
is being administered. It may cause a
malfunction or loss of glossiness.
Make sure that no items or foreign
objects obstruct any openings (air
outlets, hoses, etc.). Remove any
obstructions immediately to prevent
possible hazards and damages.
14
GB