Publicidad
Idiomas disponibles
Idiomas disponibles
1.1 g
enerAl sAfety informAtions
This operation manual is applicable for the machine
ROTO TT Vario Speed. The machine may only be han-
dled by personnel who are qualified. Suitable safety and
hygiene measures must be taken.
It is imperative that you observe the safety instruc-
tions provided separately.
The working environment must be kept clean and
well illuminated. Keep away persons in the vicinity
when you are using the hand piece. Wear tight fit-
ting clothing and secure long hair. SUHNER does not ac-
cept any liability for changes to the delivered design, the
modification or use of parts not supplied by SUHNER, or
the use of parts not designed for this specific model, in-
cluding any changes to the operating personnel's work-
flows. Electrical components must always be installed
and serviced regularly by a qualified person. This ma-
chine requires an earthed three-core plug and must be
connected to a suitable electricity supply with controlled
earthing. Do not use this machine in stagnant water.
v
Use only food grade (FDA approved) lubricants,
e.g. TURBO LUBE GREASE (Art.-Nr. 60000078),
TURBO LUBE SPRAY (Art.-Nr. 60000077). Do not
place the hand piece on a hard surface, but only in the
provided receiver.
1.2 u
se of the mAchine for purposes for
which it is intended
This machine is designed exclusively for powering SUH-
NER TURBO TRIM hand pieces SH and SHS. Make sure
that only SUHNER flexible shafts are used.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2014/30/
EU, 2006/42/EG, 2014/35/EU. Applied standards: EN ISO
12100, EN 62841-1, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3. Document Agent: T. Fischer. D-Bad
Säckingen, 10/2019.
T. Fischer/Division manager
24
100024231_AA-01_BA_ROTOTT_VarioSpeed.indd 24
100024231_AA-01_BA_ROTOTT_VarioSpeed.indd 24
1. n
S
oteS on
!
ery Sharp blade
afety
2.1 A
ssemBly instructions
2.1.1 s
uspending the mAchine
The machine must be sited properly if it is to operate for
the best possible results and counteract abnormal pos-
tures. This requires the right distance between the user
and the machine. An incorrectly mounted machine may
cause premature failure of the flexible shaft or its housing.
Further consequences are premature user fatigue and
physical discomfort. The schematic depicts the correct
siting.
2.1.2 s
upply mAchine wich electricity
It is imperative that the mains voltage agrees with
the specifications on the ratings plate.
2. c
ommiSSioning
The machine has been developed
for mounting at a certain distance
from the workplace.
08.12.2022 14:20:06
08.12.2022 14:20:06
Publicidad
