Power GD97754 Manual De Instrucciones página 92

with medium force. If this fails, continue to turn the tightening lever clockwise, or loosen it by turning
counter clockwise.
MOUNTING THE UPPER BAR (FIG.C)
1) Fasten the upper bar (1) with the enclosed screws (2b), the washers (2a) and the upper tightening
levers (2) on the right and left of the lower bar (3).
2) The release button (16) must be located on the right in the mowing direction. Two positions are
possible.
3) Turn the tightening levers (2) clockwise to fasten.
4) Lock the tightening levers (2) by pressing them in the direction of the bar (3).
5) The tightening levers must rest against the bar in such a way that tightening can be carried out with
medium force. If this fails, continue to turn the tightening lever clockwise, or loosen it by turning
counter clockwise
Note： Release the tightening levers (2,5) and fold the upper bar (1) and the lower bar (3) together so
that the device takes up less space. Make sure not to pinch the machine cables while doing this.
MOUNTING THE GRASS COLLECTION BOX(FIG.D)
1) Clip the handle (13c) of the grass collection box (13) into the upper side of the grass collection box (13).
2) Place the plastic tabs (13a) of the grass collection box (13) over the grass collection box rods (13b).
MULCH KIT (FIG.J)
ATTACHING THE MULCH KIT
1) Remove the grass collection box, if used.
2) Lift the impact protection.
3) Slide the mulch kit (18) into place. The bracket (18a) snaps into place.
REMOVING THE MULCH KIT
Push in the bracket (18a) on the mulch kit and remove the mulch kit (18).
4)
OPERATION
CHARGING THE BATTERY PACK
NOTE
 Battery and charger not included in box, it's available in Carrefour store.
 The battery can be damaged in case of improper charging.
 Remove the charger's mains plug before inserting or removing the battery.
The battery is partially charged upon delivery to avoid damage to the battery caused by a deep discharge.
Prior to initial start-up and when the battery is low, the battery should be charged. To do so, please
proceed as follows:
1) Slide the battery pack onto the charger upside down till it locks in place.
2) Insert the mains plug of the charger into a properly fused mains socket. The RED charge control LED is
illuminated; and charging requires approx. 120min for 4ah battery.
3) Wait until the RED charge control LED goes out and green charge control LED is illuminated, the battery
is fully charged.
4) Hold onto the mains plug while pulling the power cable of the charger out of the mains socket. The
battery pack and the charger may have become warm during charging, allow the battery cool down to
room temperature.
5) Take the battery pack out of the charger by pressing and holding the battery release button and pulling
the battery pack out of the charger.
92
EN