Publicidad
Idiomas disponibles
Idiomas disponibles
Machine
leaves
ragged finish and/
Motor labor
Area of cut (battery
duration) not large
enough
Cutting blade not
rotating
while
machine
switched
on
Excessive
vibrations/noise
No
charging
procedure possible
The charge control
LED
respectively,
do not light up after
inserting the mains
plug into the socket
DISPOSAL
To help the environment, please dispose of the product properly when it has reached the end of
its useful life and not in the household waste. Information on collection points and their opening
hours can be obtained from your local authority
Environmental damage through incorrect disposal of the batteries / rechargeable batteries.
Remove the battery pack from the product before disposal. Batteries /rechargeable batteries
may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and
are subject to hazardous waste treat
to the relevant local requirements
Height of cut too low
Cutting blade dull
Possible clogging
Blade fitted upside down
Height of cut too low
Grass too high
Grass wet or damp
Grass is dense
An additional battery can be
purchased from an authorized
customer service agent for
garden products
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
Battery contacts contaminated
The battery is defective, due to
a disconnection in the battery
Mains plug of battery charger
not plugged in (properly)
Socket outlet, mains cable or
battery charger defective
Increase height of cut(see "Adjusting the
Cutting Height")
Replacing the blade(see "Blade Maintenance")
Check underneath the machine and clear out
as necessary (always wear gardening gloves)
Refit blade correctly(see "Blade Maintenance")
Increase cut height and walk slower
Increase cut height and walk slower
Wait until grass is dry and walk slower
Increase cut height
more frequently
Contact Service Agent
Switch off machine Clear obstruction (always
wear gardening gloves)
Tighten blade nut/bolts
Tighten blade nut/bolts
Contact Service Agent Replacing the blade
Clean the battery contacts (e.g. by inserting
and removing the battery several times) or
replace the battery （ Batteries can be purchased
to service agents）
Replace the battery （ Batteries can be
purchased to service agents）
Insert mains plug (fully) into the socket outlet
Check power supply voltage, if necessary, a
battery charger, an authorized inspection
station contact customer service
ment rules and regulations. Please dispose of batteries according
97
, walk slower and cut
EN
Publicidad
