Power GD97754 Manual De Instrucciones página 95

17. Stop the machine, and remove the disabling device. Make sure that all moving parts have come to a
complete stop
- whenever you leave the product,
- before clearing blockages or unclogging chute,
- before checking, cleaning or working on the product,
- after striking a foreign object. Inspect the product for damage and make repairs before restarting and
operating the product;
18. If the product starts to vibrate abnormally (check immediately)
- inspect for damage,
- replace or repair any damaged parts,
- check for and tighten any loose parts.
19. Switch the product off immediately if you are disturbed while working by other people entering the
working area. Always let the product come to complete stop before putting it down.
20. Do not overwork yourself. Take regular breaks to ensure you can concentrate on the work and have full
control over the product.
21. Empty the grass collection box frequently during use. Do not wait until it is completely full. We
recommend emptying it when it is half full.
22. Make sure that the lawn is clear of stones, sticks, wire or other objects that could damage the product
or its product.
WORKING WITH THE DEVICE
Observe noise protection rules and other local regulations.
Regular mowing stimulates the grass to an increased leaf formation, while at the same time killing weeds.
Therefore, the lawn becomes denser after each mowing process, resulting in an evenly loadable lawn. The
first cut takes place roughly in April when the grass is about 70 - 80 mm high. During the main growing
season, the lawn is mowed at least once a week.
 Move the device at walking speed and in lines which should be as straight as possible. For a flawless
mowing result, the lines should always overlap by a few centimetres.
 Adjust the cutting height so that the device is not overloaded. If this not done, the motor may become
damaged.
 Always move across slopes crosswise. Take special care when going backwards and pulling the device.
 Clean the device after each use.
WARNING: Due to the intelligent energy management system, the motor starts after a delay.
After switching off the equipment, the blade continues turn for several seconds. Do not touch the
moving blade. There is a risk of injury.
CLEANING & MAINTENANCE
WARNING:
 Have any work that is not described in these operating instructions performed by an authorised
customer service centre. Only use original parts.
 Wear gloves when handling the blade.
 Switch off the apparatus, remove the ignition key ( 10) and wait for the blades to come to a
stand-still.
GENERAL CLEANING AND MAINTENANCE WORK
WARNING: Never spray down the device with water. There is a risk of electric shock.
95