Removing A Handset From A Topcom Butler 920 Base; Call Transfer And Intercom Between Two Handsets; Call Transfer And Conference Call During An External Call - Topcom BUTLER 920 Manual De Usuario

Call transfer and intercom

8.2 Removing a handset from a Topcom Butler 920 base

You can remove a handset from a base to allow another handset to be
registered.
4 5 6
g h i j k l m n o
4 5 6
g h i j k l m n o
You can only remove existing handsets other then the one you
are using.

9 Call transfer and intercom between two handsets

These functions only work when more then one handset (like a
Twin/Triple/Quattro version) is registered to the same base.

9.1 Call transfer and conference call during an external call

20
1 Press and hold the right key for 3 seconds.
2
Press and hold the mute key for 3 seconds.
PIN
3 Enter the base PIN code (0000 by default). If the PIN is
wrong, the handset will go back to standby.
PIN 1234
4
Enter the number of the handset (1-4) you would like to
remove.
If the removal is successfully, the handset will go back to
standby. If not, it will ask again to enter the handset
number.
1 During an external call, press the INT key, followed by
the number of the handset (1-4).
The other handset will start to ring:
When the other handset takes the line you can talk
internally. If you hang up, the external line will be
connected with the other handset.
H5?