DeWalt DWE402 Manual De Instrucciones página 12

4-1/2"
Type 1 guard*
unthreaded backing flange
Type 27/42 depressed
center wheel,
cutting only
threaded locking flange
115 mm) Cutting Wheels 4-1/2" (115 mm) Sanding Flap Discs
Type 1 guard*
unthreaded backing flange
Type 1/41 abrasive cutting
wheel
threaded locking flange
Type 1 guard*
unthreaded backing flange
diamond cutting wheel
threaded locking flange
Type 27 guard
hubbed sanding flap disc
* NOTE: A Type 1 guard is available at extra cost from your local dealer or
authorized service center.
Type 27 guard
unthreaded backing flange
non-hubbed sanding
flap disc
threaded locking flange
4. With the spindle facing the operator, rotate the guard clockwise
into the desired working position. The guard body should be
positioned between the spindle and the operator to provide
maximum operator protection.
5. For easy adjustment, the guard can be rotated in the clockwise
direction. The guards design allows the guard to be
rotated and adjusted by turning the guard in a clockwise,
single action motion. The lever does not need to be
depressed to turn the guard. The lever is only used for
removal of the guard. The guard can be repositioned the
opposite direction by depressing the guard release lever.
NOTE: The guard release lever should snap into one of the
alignment holes (N) on the guard collar. This ensures that the
guard is secure.
6. To remove the guard, follow steps 1-3 of these instructions in
reverse.
11