Bosch GWS 24-230 Professional Manual Original página 24

24 | English
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Notes on mains connection requirements for GWS 24-180 P and GWS 24-230 P:
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occa-
sional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Z
user must make sure, that the connection point, with the impedance Z
impedance requirement: Z ≥ Z
actual
thority.
Values can vary depending on the product, scope of application and environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
Angle Grinder
Article number
Rated power input
A)
Rated no-load speed
Max. grinding disc diameter/rubber sanding pad dia-
meter
Grinding spindle thread
Max. thread length of grinding spindle
Restart protection
Soft start
Overload protection
B)C)
Weight
Protection class
A) Rated no-load speed for the selection of appropriate application tools in accordance with EN IEC 62841-2-3. The actual no-load speed
must not exceed the rated no-load speed and is therefore lower.
B) Depends on protective guard ((8), (7), (9)), auxiliary handle ((5), (4)) and extraction guard (25) in use
C) Weight without mains connection cable and without mains plug
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Values can vary depending on the product, scope of application and environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
Noise/Vibration Information
Noise emission values determined according to EN IEC 62841-2-3.
Typically, the A-weighted noise level of the power tool is
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to EN IEC 62841-2-3:
h
Surface grinding and abrasive cutting:
a
h
K
Disc sanding:
a
h
1 609 92A 9HP | (25.03.2024)
. If Z is unknown, determine Z
max max
min
mm
mm
kg
GWS 24-180
3 601 HC2 0..
dB(A) 95
dB(A)
103
dB
3
2
m/s 7.9
2
m/s
1.5
2
m/s 2.9
, on which the appliance shall be plugged in meets the
max
in consultation with the network supplier or supply au-
max
GWS 24-180 JZ GWS 24-230 JZ GWS 24-230 PZ
3 601 HC2 3.. 3 601 HC3 3..
W 2400
–1
8500
180
M 14
25
●
●
●
5.6–7.8 5.8–8.8
/ II
GWS 24-230 GWS 24-180 P
3 601 HC3 0.. 3 601 HC2 1..
95
103
3
7.9
1.5
2.9
= 0.16 Ω. The
actual
3 601 HC3 4..
2400 2400
6500 6500
230 230
M 14 M 14
25 25
● ●
● ●
● ●
5.8–8.8
/ II / II
GWS 24-230 P
3 601 HC3 1..
95 95
103 103
3 3
7.9 7.9
1.5 1.5
2.9 2.9
Bosch Power Tools